Wednesday 25 April 2018

Changing the baud rate on a Cisco 3650

Unfortunately the only way to do this is from ROMMON mode - so in order to easily access it we can instruct the switch to automatically enter it on the next reload:

conf t
boot enable-break

or alternatively power of the switch, hold down the 'Mode' button, turn the switch on (while still holding the 'Mode' button) for around 15 seconds.

Then set the baud rate appropriately:

set BAUD 9600

boot the IOS image:

flash_init
boot

and finally once it's booted up ensure that we revoke the 'enable-break' command:

conf t
no boot enable-break

0 comments:

Post a Comment